WORC101 – 4 Channel Wireless Output Remote Control

THIS PRODUCT HAS BEEN DISCONTINUED AND IS NO LONGER AVAILABLE – FULL WIRELESS SYSTEM REPLACEMENT IS REQUIRED – PLEASE REFER TO THE BELOW PART NUMBERS FOR NEW WIRELESS SYSTEM

SKU: WORC101

$709.28

100 in stock

Description

THIS PRODUCT HAS BEEN DISCONTINUED AND IS NO LONGER AVAILABLE

FULL WIRELESS SYSTEM REPLACEMENT IS REQUIRED

PLEASE REFER TO THE BELOW PART NUMBERS FOR NEW WIRELESS SYSTEM:

  • WORCS201 (Wireless Receiver)

 

The WORCS is a wireless control system
that will allow you to control 4 outputs, which are N/O. One
of the outputs

can be switched to N/C if needed. These outputs can be
changed to positive or negative by changing the internal fuse location

in the receiver with a maximum positive output of 15 amps. The receiver
is programmable to send either a pulse or a latch signal.

The transmitters are programmed to the
receivers by using a computer with a Windows operating system.

By
following the WORCS Manual you can set up the Windows Hyper Link
software to allow you to program up to 6 transmitters

for each receiver.

The hand held transmitters have a range
of approximately 200 feet depending on any physical obstructions that
might impede

the signal reception.

The WORCS can control what you would
have normally controlled before with an on/off toggle switch, such as

  •  PTO Pump
  •  Engine RPM
  •  Valve Open/Close
  • Solenoids
  • Engine Start/Stop,
    etc..

This system comes with a one year manufactures limited warranty.