WORC101 – 4 Channel Wireless Output Remote Control
THIS PRODUCT HAS BEEN DISCONTINUED AND IS NO LONGER AVAILABLE – FULL WIRELESS SYSTEM REPLACEMENT IS REQUIRED – PLEASE REFER TO THE BELOW PART NUMBERS FOR NEW WIRELESS SYSTEM
$709.28
Description
THIS PRODUCT HAS BEEN DISCONTINUED AND IS NO LONGER AVAILABLE
FULL WIRELESS SYSTEM REPLACEMENT IS REQUIRED
PLEASE REFER TO THE BELOW PART NUMBERS FOR NEW WIRELESS SYSTEM:
- WORCS201 (Wireless Receiver)
The WORCS is a wireless control system
that will allow you to control 4 outputs, which are N/O. One
of the outputs
can be switched to N/C if needed. These outputs can be
changed to positive or negative by changing the internal fuse location
in the receiver with a maximum positive output of 15 amps. The receiver
is programmable to send either a pulse or a latch signal.
The transmitters are programmed to the
receivers by using a computer with a Windows operating system.
By
following the WORCS Manual you can set up the Windows Hyper Link
software to allow you to program up to 6 transmitters
for each receiver.
The hand held transmitters have a range
of approximately 200 feet depending on any physical obstructions that
might impede
the signal reception.
The WORCS can control what you would
have normally controlled before with an on/off toggle switch, such as
- PTO Pump
- Engine RPM
- Valve Open/Close
- Solenoids
- Engine Start/Stop,
etc..
This system comes with a one year manufactures limited warranty.